Hi everyone,
I recently had my wheel alignment done on my 1990 Convertible.
I knew I had an issue with the rear wheels after a bump put the drivers side (RHD) out and have sourced a secondhand rear axle. I will have this blasted and coated. Which bushes should I replace and should I go for poly bushes?
I was also concerned when I looked at the printout for the front wheels. They have been adjusted but still look out of alignment to me. However I am a novice and do not know what the readings relate to.
I have attached a copy of the wheel alignment read out and was hoping somebody might understand it and advise me on how to correct it. Do I need any new parts etc.
I recently had my wheel alignment done on my 1990 Convertible.
I knew I had an issue with the rear wheels after a bump put the drivers side (RHD) out and have sourced a secondhand rear axle. I will have this blasted and coated. Which bushes should I replace and should I go for poly bushes?
I was also concerned when I looked at the printout for the front wheels. They have been adjusted but still look out of alignment to me. However I am a novice and do not know what the readings relate to.
I have attached a copy of the wheel alignment read out and was hoping somebody might understand it and advise me on how to correct it. Do I need any new parts etc.